Skip to main content
Fisher & Paykel Product Help

Hanging Ice and Water Door Panel

 

1. Remove the external display module from inside the product.

Thread the display harness through the door panel cavity. Ensure the grommet is engaged.

2. Angle top display tabs into the door panel. Ensure the harness is free of pinching. Firmly push against bottom display tabs and insert into the door panel until you feel it clip securely. Ensure the display is flush with the door panel.

2018-01-08_1327.png

3. Remove water tube from holder on the refrigerator door.

4. Hang door panel onto M8 studs. Ensure the panel is free to pivot for water connections (refer to A).

2018-01-08_13271.png

5. Connect the display harness onto the refrigerator door by firmly inserting until you feel it clip securely (refer to B).

On the external display, enable the dispenser lock, this will help prevent any water from dispensing during water connection. To lock, press the 2018-01-08_1350.png button for 4 seconds. The LED above the button will illuminate.

2018-01-08_1343.png

6. Firmly push the water tube into the spigot behind the door panel until the marked line is not visible. Ensure the water tube is routed away from any sharp objects, sharp corners, and not in a location where it can be kinked or squashed when the door panel is secured, (as this will stop water flow).

To secure door panel, follow the instructions in the next section: ‘Hanging non-Water dispensing door panels’.

54.png

 

  • Was this article helpful?